Hi,
I know that this is a know issue but I can't find any thread describing directly what to do..
I am building a 100w amp with 4xEL34 and 5x12AX7 tubes and I measure the heater voltage to 7.2VAC. The amp works fine so far but I wan't test it further to avoid frying the tubes.
How do I get the voltage down?
Thanks
Thomas
I know that this is a know issue but I can't find any thread describing directly what to do..
I am building a 100w amp with 4xEL34 and 5x12AX7 tubes and I measure the heater voltage to 7.2VAC. The amp works fine so far but I wan't test it further to avoid frying the tubes.
How do I get the voltage down?
Thanks
Thomas
Comment