Announcement

Collapse
No announcement yet.

Mid 90’s Line 6 AXS2 212 amp ( squeal in one channel)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mid 90’s Line 6 AXS2 212 amp ( squeal in one channel)

    Neighbor gave me this AXS2 212 modeling amp that was dead when I got it. Solid state amp.
    Turns out by cleaning the pots it’s works great. This thing has 4 banks so you can switch between all sorts of amp models. Works great except when I switch to bank 4 I get a loud squeal.

    I eyeballed the board and see nothing obviously physically damaged. I don’t have a schematic either.
    From the symptom, best place to start troubleshooting?

    thanks.

  • #2
    Have you cleaned ribbon cable connections? Done a factory reset? Are you using a floorboard or controlling from the front panel?

    Comment


    • #3
      Acts Same with floorboard or front panel.
      Did a factory reset.
      Have not (but good idea) cleaned anything other than the pots and switches.

      Comment


      • #4
        I can't remember if there are some socketed memory chips on this, but I would also make sure any socketed chips are fully seated.

        Comment

        sisli escort mecidiyekoy escort
        pendik escort
        sex vidio
        altyazili porno
        antalya escort
        beylikduzu eskort bayan eskort bayan escort antalya sirinevler bayan escort
        gaziantep escort
        atasehir escort
        antalya escort bayan escort atakoy
        izmit escort
        ankara escort
        Sex ?zle
        Working...
        X