BF/SF Fender reverb sends for both channels?

[Groover]

I have most of my BF & SF Fenders modded to mix the channels before the reverb, which results in the reverb and tremolo affecting both channels.

However I would like to be able to have reverb in both channels, but have the tremolo only on one, and possibly a master volume on only that channel as well.
So I guess I would need to add a separate reverb feed for each channel.

Has anyone done this? Is this possible without adding a tube? Can I mimic the tap off the V2b coupling cap on the V1b coupling cap, and use a Y of summing resistors to feed the grid of the reverb drive tube?

[pdf64]

Try using a 330pF or 470pF cap to link 'X' on the layout diagram, p2 of
http://www.schematicheaven.com/fende...b763_schem.pdf
to the grid of the reverb driver, pin2&7 V3 (eg the hot side of the it's 1M grid feed resistor on the board).
Hope that's clear, ask if not.
Idea is from jazzguitar on fenderforum.