Mixing 2 Channels for Reverb

[Dagan8]

I think your NFB loop is very carefully condidered. At first the ratio looked low. But then I saw that you have it coupled from the two ohm secondary. So I'm guessing you considered ratio and tap based on something like the Super Reverb? Looks just fine.

You guessed correctly!

I like to hardwire a 47pf "bright" cap and then use a 100pf on the switch. The bright switch a fun circuit for tweaking.

I like this idea. I will hard wire a 47pf cap and switch in a second parallel 47pf for bright.

I've gone as small as 2200pf, but I usually use a value of 4700pf or .01uf. Just something to consider.

Thanks for the tip.

I am going to make some final edits and post the completed schematic in a new thread for more criticism before I put iron to eyelet. Right now I am debating using a smaller PT and running 6V6's since this is for home use. I want it for primarily for cleans but I'm sure 22 watts will be plenty. I would just use the same OT since I already have it and re-label the taps 4,8,16 instead of the current 2,4,8 to compensate. The over sized OT may help with the clean headroom anyway.

I have an 18watt EL84 build that I use for my dirt.

Cheers