If you do dual supply, you have to be careful in what IC you use. They can latch up if the power sequence is not correct. I think opamp is usually safe to lost one rail, but many other IC will hung if the power up sequence is not right. I actually went to Linear Technologies to show them one of their ADC latched up with our power supply and they were red faced. That's the reason I did not go with single supply. If it is just opamps, it is very easy, definitely simpler than to have to extra transistors to turn voltages on.
Attached is a typical schematic that use single supply. Opamp is on +9V and ground. Input is biased a 4.5V. It is easy as they are all AC coupled. There is no power up or input being grounded problem.
Attached is a typical schematic that use single supply. Opamp is on +9V and ground. Input is biased a 4.5V. It is easy as they are all AC coupled. There is no power up or input being grounded problem.
Comment