Tweet
Hello. I'm new to this forum. I'm sure this question has been asked, but I couldn't find an answer on this forum, or anywhere I looked.
If you look at a page like Aiken Amplification, they always have these nice pictures of plate characteristics and they draw load lines over them and they say something along the lines of: "At this point, the tube is drawing 1.15 ma."
Are they using something like MatLab to do this? If so, are they able to draw a load line and have the software calculate the volts and amps? I understand that you can figure out the values by tracing straight lines down and across, but they always seem to quote more precise numbers.
Thanks in advance,
BrianB
If you look at a page like Aiken Amplification, they always have these nice pictures of plate characteristics and they draw load lines over them and they say something along the lines of: "At this point, the tube is drawing 1.15 ma."
Are they using something like MatLab to do this? If so, are they able to draw a load line and have the software calculate the volts and amps? I understand that you can figure out the values by tracing straight lines down and across, but they always seem to quote more precise numbers.
Thanks in advance,
BrianB
Comment