Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

Transformer question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Transformer question

    Why is it bad to run a output transformer without a load (no speaker attached) yet it is okay to run a power transformer without a load (all the tubes pulled)?

  • #2
    In principle no-load operation is no problem for a transformer.
    But in the amp the OT is an integral part of the output stage and if you disconnect the secondary load, the power tubes may produce kVs across the large primary inductance, likely to damage the insulation of the OT.
    Last edited by Helmholtz; 10-21-2021, 07:30 PM.
    - Own Opinions Only -

    Comment


    • #3
      Just spitballing here, but I think OTs tend to have a much higher inductance, which means more reactance and higher 'kickback' voltages as a result. Hundreds of volts are typical not a problem for windings, but thousands of volts can arc and destroy the wire insulation.

      Comment


      • #4
        Well, there's real no reason for mains voltage to rise when you disconnect the load from a PT.

        - Own Opinions Only -

        Comment


        • #5
          Originally posted by Helmholtz View Post
          In principle no-load operation is no problem for a transformer.
          But in the amp the OT is an integral part of the output stage and if you disconnect the secondary load, the power tubes may produce kVs across the large primary inductance, likely to damage the insulation of the OT.
          ^^^^^^ That. The transformer is part of a circuit, and the question of loading has more to do with the circuit than the transformer itself.
          "I took a photo of my ohm meter... It didn't help." Enzo 8/20/22

          Comment


          • #6
            Mains is a voltage source (low impedance) so load does not change it.
            120V no matter what, loaded or open.
            Even on a HV secondary: you have 400VAC? ... you will always have them, or less (because of losses)

            But tubes are current sources, they will keep injecting current into OT even if such energy is not absorbed at the other end (speaker secondary) so will develop HIGH voltages at primary side.

            Even worse, since they are inductive, switching current ON-OFF (exactly what overdriven tubes do) will develop kilovolts, remember they *start* with around 400-450V DC which is already half a kilovolt
            Juan Manuel Fahey

            Comment

            gebze escort kurtköy escort maltepe escort
            pendik escort
            betticket istanbulbahis zbahis
            mobile casino no deposit bonus
            deneme bonusu veren siteler bonus veren
            deneme bonusu deneme bonusu veren siteler Canlı casino siteleri
            mobilbahis rokubet
            deneme bonusu veren siteler bonus veren siteler
            bonus veren siteler
            deneme bonusu veren siteler
            deneme bonusu
            casino siteleri
            atv-youth.org Deneme Bonusu Veren Siteler Deneme Bonusu Veren Siteler sherlockimmersive.com
            onwin
            alanya escort gaziantep escort gaziantep escort gaziantep escort mersin escort
            deneme bonusu
            deneme bonusu veren siteler
            deneme bonusu veren siteler grandpashabet
            deneme bonusu veren siteler deneme bonusu veren siteler
            casino siteleri
            deneme bonusu veren siteler
            deneme bonusu veren siteler
            güncel deneme bonusu
            streameast
            bahis siteleri
            Working...