First off I did not wire this monster, I am picking up the pieces from the person that gave me the amp. With that said, came in this evening put the ohm meter on the second side of 10k to gnd now it's readings 1.16 Mohms... something changed..
The 220k resistors measured ok,
While started my trace...at the 20uf side of the 2nd 10k there is a wire that goes to the 12AX7, pin 8, cathode, that's not on my drawing.. (refer to first sentence) I snipped it at the resistor, did not have an effect on the 1.16 Mohms.. Kinda difficult to visually trace this 2 sided board. I removed it and all the pots and inputs. when the board released from the stand off the meter went to 000. There was a splat of loose solder on the chassis, and was the only visual inconsistency found.
That all the time I have this evening, I'll continue tracing tomorrow night.
does that cathode wire make sense?
Thndr
The 220k resistors measured ok,
While started my trace...at the 20uf side of the 2nd 10k there is a wire that goes to the 12AX7, pin 8, cathode, that's not on my drawing.. (refer to first sentence) I snipped it at the resistor, did not have an effect on the 1.16 Mohms.. Kinda difficult to visually trace this 2 sided board. I removed it and all the pots and inputs. when the board released from the stand off the meter went to 000. There was a splat of loose solder on the chassis, and was the only visual inconsistency found.
That all the time I have this evening, I'll continue tracing tomorrow night.
does that cathode wire make sense?
Thndr
Comment