Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

cambridge audio AZUR 540A in protection mode

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cambridge audio AZUR 540A in protection mode

    Hello all
    Having a few issues with this one
    It came in in protection mode. 1/2 of the speaker outs were broken
    So i sorted those out. and turned on in protection mode
    I tested the SAP15N- SAP15P. I thought they were faulty. I replaced with SAP16's ( bought from a good supplier ) which is an updated version of the SAP15
    I believe now that the sap15 were ok
    I have read a few bits on line about this problem but nothing that is helpful
    cambridge_azur-540a_v2.0_sm.pdf
    They used that glue on the main board that has gone bad and hard eating into component
    legs. Cleaned that off and only found 1 damaged leg. sorted that

    At switch on i press standby and within 2-3 seconds it shuts off and power supply relay cuts the supply from the power tx
    at switch on i can see about 30v on J12 ( page 26) and 1.5V on J6 page (26)
    of course this lasts for about 3-4 seconds then drains away
    I have tested transistors/diodes/resistors in power amp circuit nothing comes up bad
    38v +/- ok
    15v+/- ok
    5v ok

    Is there anyway to disable the protection so i can get this on ?? so further tests can be made and hopefully work out what is going on
    thanks in advance

    BBB
    Last edited by blindboybenton; 02-28-2020, 03:09 PM.
Working...
X