inside MXR dynacomp!!!???

[Jay]

Hello
I need to see some pictures of inside of a MXR dynacomp from 70’s.
From the pcb and the switch and all.
If you have some pictures please let me know .


Thank you all in advance

[Mark Hammer]

What do you need to know?

[Jay]

Mxr

I need to know where to connect 3 lose wires

Orange yellow and gray are lose.

[Ray Ivers]

Jay,

I've got mine open in front of me (pots up, PCB standing straight up). The orange wire runs between the far-left terminal of the left (Sensitivity) pot & the upper-right solder blob on the bottom of the PCB, and the gray wire goes to the center terminal of that same pot & the lower-left solder blob on the bottom of the PCB (no connection to the right-hand pot terminal). The yellow wire runs from the same Input-jack terminal the other yellow (switch) wire connects to, to the right-center solder blob on the PCB bottom. For reference, there's also a brown wire from the upper-right of the PCB to the switch.
Let me know if you need the PCB connections and/or a pic (which I can E-mail to you). My unit is red, w/lower-case 'dyna comp' lettering.

Ray

[Jay]

Thank you

Ray

Thank you so very much.
By your help my MXR works now.

Thank you

[Ray Ivers]

Jay,

No problem at all - glad to help. I'm actually happy I opened mine up, as both the box packing foam and PCB-insulating foam were quite deteriorated, and the battery was nearly dead! I better check the other ones now too...

Ray

[strat321]

hello-
I'm a newbie and need similar help I have an 80's or 90's MXR M-102. I need a picture to help me out. Do you still have the picture mentioned above 4 yrs ago?

[strat321]

anyone with a 80's 90's dyna comp photos of the inside?
thanks

[Howlin' Mad Mac]

Check out Monte Allum's Mod site... if memory serves he's got pix of several different iterations of the dyna comp pictured so u can order the right parts to mod whichever version you happen to have