TS808 SRV Special?

[ArnC.]

Howdy Folks!

I built this from the schematic at JC Maillet's site. It calls for a 1M Audio taper for the Gain. I also read where some put in a 2M Audio taper there also. I tried the 2M and it was too gainy. Not much control. I was looking for a 1M Audio taper but only have linear, but I do have a 500K audio taper. What or which should I use? Any suggestions appreciated.


How much difference would a 1M Linear pot make if I decided to use one?



Thanks!
Arn C.

[alligatorbling]

Honestly you could use either one. I think I tired a 1M Linear in one once and it wasn't to much of a terrible diff, maybe not quite the smooth roll of a log for obvious reasons but it will work. Try both and see what suits your taste best.

[ArnC.]

Thanks Gator! I ended up removing a 1ma from another unfinished product.


Peace!
Arn C.