Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

Ground loops in a guitar ?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ground loops in a guitar ?

    I know it exist in Amp building but in a guitar ? I'm not convinced & i keep hearing this from newbies .........or players with more basic understanding .
    go ahead let me know what you think ...................
    "UP here in the Canada we shoot things we don't understand"

  • #2
    I would think only when people mis-use the term ground loop. Many people call anything making hum a "ground loop". To me, a ground loop occurs when two pieces of equipment have differing ground potentials are connected together by an additional ground path, like a cord between two amps. I am not sure how you could have multiple current paths in the ground inside my guitar.

    But I freely admit I am not a guitar guy, I am an amp guy.
    Education is what you're left with after you have forgotten what you have learned.

    Comment


    • #3
      +1
      The differential voltages and relatively short ground leads in a guitar (even relative to their low output and that they will be extremely amplified) seem too low to be problematic. I've never had a particular guitar that seemed to hum more than usual unless it was a gain issue more related to hot pickups. I do know I've read about it happening though. Since I don't have those suspect guitars on my bench I can't verify one way or the other. But I lean toward "Not a problem".
      "Take two placebos, works twice as well." Enzo

      "Now get off my lawn with your silicooties and boom-chucka speakers and computers masquerading as amplifiers" Justin Thomas

      "If you're not interested in opinions and the experience of others, why even start a thread?
      You can't just expect consent." Helmholtz

      Comment


      • #4
        If you run the ground wires in a path that forms a closed loop, I suppose you technically have a loop antenna - which is not the same thing as a ground loop as Enzo elucidated. But I doubt it will make any difference.

        Just don't ground your guitar like this:

        Last edited by rjb; 07-05-2017, 05:56 PM. Reason: Removed redundant "the same"
        DON'T FEED THE TROLLS!

        Comment


        • #5
          The ground loops by itself is not a big deal (I saw a lot of working circuits with mistakes) the problem is difference of potential between path in a loop which determine a current to run modulating the signal. Good practice should avoid it.
          "If it measures good and sounds bad, it is bad. If it measures bad and sounds good, you are measuring the wrong things."

          Comment


          • #6
            I work on guitar electronics pretty much every day, day-in, day-out. I've never seen a guitar that's had a 'ground loop' (in the conventional sense of the term). If this were possible, then guitars would need to be bus connected, or star-grounded. Sure, there are numerous ground issues that can occur, but the potentials, current flow and resistances involved make the scenario theoretical and based on micro-potentials which would make no audible difference.

            I say that fully with the knowledge that I have a customer who swears he can hear the difference between pickup selections on a Les Paul when the guitar is played acoustically and not plugged in. So, I guess 'hearing' ground loops for some is eminently possible, as are voices from the spirit world.

            Comment

            Working...
            X