P90 Soapbar question

[Chris Klein]

Does anyone have any pictures and/or suggestions on what is the best way to start the wire on P90 bobbins? So far I have read that eyelets and humbucker wire leads are some of the ways to start/end the coil wire. Any other ideas or pictures?

[Stan H]

I normally just do mine the same way I do humbucker bobbins, by taping the start to the winder plate and then attaching the pigtails when I've finished the coil.

[David Schwab]

I attach the pigtail to the magnet wire, and then tape it to the inside of the bobbin, either poking it through a hole, or just over the edge, and start winding.

Lately I forgo the holes , and just have both pigtails coming out one side of the bobbin to make it easier to attach the leads.