I made a bobbin holder....

[Viktor Johanson]

...with some very useful help from a few friends!

It's simple but I think it will work fine.

A friend turned it from a piece of stainless steel, then I drilled two 1,8mm holes through the disk. The bobbin is attached using 1,6mm screws (I will get some shorter ones soon ) and nuts.

The shaft is 8 mms in diameter, the disk has a diameter of 50 mms and a thickness of 5 mms.

[David King]

Viktor,
That's quite lovely looking.
You may end up ditching the nuts and screws in favor of tape. It's much faster to change out bobbins.

[orangedrop]

...with some very useful help from a few friends!

It's simple but I think it will work fine.

A friend turned it from a piece of stainless steel, then I drilled two 1,8mm holes through the disk. The bobbin is attached using 1,6mm screws (I will get some shorter ones soon ) and nuts.

The shaft is 8 mms in diameter, the disk has a diameter of 50 mms and a thickness of 5 mms.

Snygg!