Eyelet Installer

[David Schwab]

i was planning on just glueing or similar a piece of copper for the input and output with 2 holes in it, one to solder the wire from the winding and one to solder the wire that goes the the electronics...

I've done that. I used some copper clad perf board and glued it to the bobbin.

Now I use "flea" clips.

[NightWinder]

Which one does he use?

[David Schwab]

Which one does he use?

Who? Flea?

[NightWinder]

Nooo. Muris Varicij- Stan's customer. He's a seriously great guitar player

[Stan H]

Nooo. Muris Varicij- Stan's customer. He's a seriously great guitar player

Viper Bridge, Desperado Neck and LaGrange Middle.

[NightWinder]

Hum, I seen in the video that he was using a musicman. Your site is very user friendly too. Cool beans......

[Zhangliqun]

Before. And no, they don't. The rivest stick out just a hair above the flatwork, and when I flair it and mash it, it's flat again.

True -- but I also just put some scotch tape over the eyelets before winding to make doubly sure the wire never catches on them.