Filtertron alnico 5 magnets 1/4" thick

[Claus H]

Hi pickup buddys I am Looking for cast ALNICO 5 magnets 2.444'' long x 0.500'' wide x 0.250'' thick for filtertron pickups, anybody have a clue of where to find these
Claus H

[sprocket]

Hi pickup buddys I am Looking for cast ALNICO 5 magnets 2.444'' long x 0.500'' wide x 0.250'' thick for filtertron pickups, anybody have a clue of where to find these
Claus H

It looks much like what you want but a little different , don t know if you can do something with it : ALNICO 5 BAR MAGNET - 2.444" x .492" x .125" - Model PP-750 | eBay

[David Schwab]

It looks much like what you want but a little different , don t know if you can do something with it : ALNICO 5 BAR MAGNET - 2.444" x .492" x .125" - Model PP-750 | eBay

He wants 1/4" thick. That's 1/8" thick.

Wasn't there a thread about this here recently? Oh yeah, it was about the screws.

[sprocket]

He wants 1/4" thick. That's 1/8" thick.

Wasn't there a thread about this here recently? Oh yeah, it was about the screws.

Woops , 1/4 & 1/8 th s not the same right

[marku52]

yeah but if you stacked 2 of them side by side to make .250", what would be the difference? Should work the same as a single mag. No flux is coming out those sides anyway.

[David King]

Can't Magnetic Hold grind these for the OP?

[Peter Naglitsch]

I buy my 1/4" thick A5 bars from Sensmag. I think it was a custom order, but as I got a few other standard sizes they didn't charge me extra for the custom work and the shipping was still OK as I got a few hundred bars at the same time

[Possum]

You can superglue or use silicone caulk to glue them together then magnetize them as a unit, it works and I've done it with the Valco repro, if its magnetized through the thickness it might also work for you, alnico 5 seems to magnetize on the 3 axis points, but only have tried 2 of them myself.