49mm P90 bobbins -- cheap!

[Zhangliqun]

I forget who I ordered them from but I can't use them -- unless somebody knows where to get 49mm covers?

If not, I have 38 of them, yours for $38 plus shipping and Paypal. Email me at zhangbucker@yahoo.com.

[David King]

Photo?

[Bryan Jeppson]

Just sent you an email. I'll take'em.

[Zhangliqun]

SOLD!

Now, I've got some 50mm bobbins from Mojo that I have no use for either. 39 of them. Crummy photo below, in spite of which you can see the start lead slot at the end of the bobbin on the right, a feature I don't care for because of potential snag problems. They're also a bit shallow, about 1mm shallower than the Allparts bobbins I prefer.

They have the funky texture on top and bottom which you can sort of see in the photo which is neither here nor there for me but just so you know.

The upside is the molding of these is very clean, very little deburring/sanding/etc required, except that I would smooth out that slot as much as I could. Will unload them for $1 apiece too plus shipping, or best offer. (I'll eat the Paypal fee.)