soldering coil leads without an eyelet - what's the secret technique?

[spichael]

soldering leads without eyelets

Yes you do solder the wires together at the end I won't be at work untill Monday but I will set a reminder to take a picture sorry for the poor discription I know its a confusing process to explain

Here ya go! I how these help!
I also included a image of taping in case that was an issue

[mr fab]

I am not sure if this will work, but maybe using solder paste, as used on SMT lines may be an option. normally this paste is heated/reflowed using a fine hot air jet. obviously it maybe overkill to invest in a SMT workstation just to avoid using eyelets, but I guess it is one solution.

I am also unsure if the temperature will get hot enough to melt insulation on the wire

[Beef Coon]

I use hemostats with the locking bits ground off for "threading" eyelets.