P90

[SpareRibs]

I would like to make a p90 using forbon with a maple spacer for the bobbin. I have
not been able to find out how thick the maple spacer should be. I would like it to be
as close to original as possible so as to avoid muddy or sharp tones due to height of
finished coil. Thanks for any help offered.

[big_teee]

I would like to make a p90 using forbon with a maple spacer for the bobbin. I have
not been able to find out how thick the maple spacer should be. I would like it to be
as close to original as possible so as to avoid muddy or sharp tones due to height of
finished coil. Thanks for any help offered.

I don't have one too measure, but I think the inside thickness should be around 1/4 inch.
Similar thickness as a standard humbucker bobbin.


Good Luck,
Terry