Tweet
Hello all,
This is the first post for me since I joined this site. First I must say how grateful i am for getting to know this awesome forum and for all the great information I found and learned here
Although I have been winding more tan 10 pickups so far, I keep having trouble with wire winding. I usually set speed at about 600 rpm. At the end, I always find wire is bulging out at the center of long bobbin edge. I sometimes had to literally press the proud wire bundle into the bobbin space using tape.
Is there any "golden rule" to wind wire tight enough, i.e., no bulging out?
This is the first post for me since I joined this site. First I must say how grateful i am for getting to know this awesome forum and for all the great information I found and learned here
Although I have been winding more tan 10 pickups so far, I keep having trouble with wire winding. I usually set speed at about 600 rpm. At the end, I always find wire is bulging out at the center of long bobbin edge. I sometimes had to literally press the proud wire bundle into the bobbin space using tape.
Is there any "golden rule" to wind wire tight enough, i.e., no bulging out?
Comment