Peavey CS-800 Series C

[tjsilva]

Well, I replaced the triac boards and buttoned up the unit unfortunately channel B now gives me no sound. No resistance at the output terminals. I will crack her open tonight and see what I come up with. Man I thought I was done, hpoefully just a connector unplugged as channel B's triac board is hard to get to.

[clintronics]

There is a 4 wire connector that connects to the ouput XSTR PCB. Make sure 1 to each channel is plugged in.

you should have about 3.7K ohms on the output jacks

[tjsilva]

Ok cracked her open and found 1 connector off on the input of channel B she is good to go. Thank You all for your help, especially you Enzo you are a wealth of knowledge. I will continue to follow your conversation on the Peavey forum to further my education on these amps. Thanks again.