Tweet
I have an Ibanez SR500 Bass Guitar.
The one with active bass/mid/treble controls and a cut off switch that cuts out the tone controls.
Does anyone have the pick-up + pre-amp schematic or wiring diagram for this Bass.
There was a link on this forum for Ibanez wiring diagrams but it wouldn't work.
Likewise, the Ibanez "Support" links are also dead.
The bass occasionally just cuts out only to reconnect by thumping the guitar cord at the jack.
My confusion with the jack is that it is a stereo jack with three conductors. It has only been used by my bass player in single ended mode. Are there three conductors to:
1. generate a balanced output,
2. to run two output signals in stereo,
3. to generate some kind of ground for the battery and active electronics?
The jack in connected with 1 white and two black wires. Only one of the black wires is common with the pot cases.
The one with active bass/mid/treble controls and a cut off switch that cuts out the tone controls.
Does anyone have the pick-up + pre-amp schematic or wiring diagram for this Bass.
There was a link on this forum for Ibanez wiring diagrams but it wouldn't work.
Likewise, the Ibanez "Support" links are also dead.
The bass occasionally just cuts out only to reconnect by thumping the guitar cord at the jack.
My confusion with the jack is that it is a stereo jack with three conductors. It has only been used by my bass player in single ended mode. Are there three conductors to:
1. generate a balanced output,
2. to run two output signals in stereo,
3. to generate some kind of ground for the battery and active electronics?
The jack in connected with 1 white and two black wires. Only one of the black wires is common with the pot cases.
Comment