OK Then

[Tone Meister]

Well I'll guess that the signal is padded between the second preamp stage and the power tube grid then. It's very hard to see what all is going on in the pics because of the angle of shots and, of course, the nature of the wiring as it is. But what is THIS resistor doing? (circled in red) It sort of hides behind other stuff in all but this shot and I can't see well what it's connected to.

That is one of the 100K

Ok. Then what is this one doing? It's clearly a different resistor.

THAT is the grid leak, yes. My bad

edit: so the resistor in post #78 is actually 100K ?

Yes, 100K

Who's in here:


[ATTACH=CONFIG]52324[/ATTACH]

Another 10K in SERIES with another to make up the 22K?? Off the screen to the last filter cap, I reckon

[Chuck H]

Post removed as a courtesy.

[g1]

If it's just going to be guesswork and reckoning, might as well take a wild guess at what's causing the power reduction and close up the thread.
Are you having a laugh? How hard can it be to check components against a simple 20 part schematic?
Good luck.