Announcement
Collapse
No announcement yet.
Search Result
Collapse
79 results in 0.0125 seconds.
Keywords
Members
Tags
-
Check Q1000,1200,1201. They're on the preamp schematic, or, if you have the preamp board out, they're around their respective controls(main and monitor master...
-
Arrrggghhh.. I typed in VK-9 in the title when I meant VK-8, as I typed in the body of the message. I have the Black Magic page bookmarked, but had not seen...
Leave a comment:
-
Schematic for Roland VK-9 power supply
Would anyone have a schematic of a Roland VK-8 organ. One was brought to me to be repaired, the headphone jack was broken. After replacing the jack and 3...
-
Steve, If you are looking for LM308 chip, build your own clone has them listed on their site.
Leave a comment:
-
Check your pedal out when you get it and if you need one, let me know, as I have one.
Leave a comment:
-
-
PV XR8300 feedback LED's dimly lit on monitor channel eq
A friend brought me a Peavey XR8300 powered mixer that functions OK, but the LED's for the monitor channel are dimly lit all the time. They light up brighter,...
-
What brand of guitar is this?
Does it have metal endplates?
I've never seen a ground wire on any of mine that I've owned, other than pup ground...
Leave a comment:
-
I'm a little late to the party.... I found a pdf. parts list on their website, don't know if yours is in there.
Did you try calling TC Furlong? They're...
Leave a comment:
-
Donnie, Glad to hear that worked for you! It's happened to a few of those amps. I forgot about the fxloop jacks on the front. Give them all a good clean...
Leave a comment:
-
Donnie, if you have a spare cable, plug one end into the fx send and the other into the power amp in jack. If that brings it back to life, then you can try...
Leave a comment:
-
The effects loop jacks get oxidized over the years and cuts out/lowers the volume. Try plugging a cable into the fx loop jacks to see if that cures it.
Leave a comment:
-
Leave a comment:
-
Did you get your schematic? You can email the service dept. and they will send you the schematic. Usually they will ask for a board # and possibly a serial...
Leave a comment:
-
Mackie 808S preamp resistor wattage value
I have a Mackie 808S mixer with a channel(#7,stereo) that has low output for the mic input and is noisy(crackles). The stereo line input gain is fine. I've...
-
Check R57,58. These are the plate load resistors for the phase inverter and I have seen these resistors open up on a few of these amps.
Leave a comment:
-
Is there another input on the back of the unit? If so, try plugging in there to see if that makes a difference.
Leave a comment:
-
That looks like an Ampeg transformer. Bruce might have a suitable replacement available or check out what's available at Allen amps, if you want to get the...
Leave a comment:
-
That looks like a CS800 C series, with the pull for DDT on the volume pots. You can get that schematic from Peavey. Call or send them an email.
Leave a comment:
Leave a comment: