Dual Marshall Footswitch

[Vanink]

I have a Marshall MG100DFX, amp works great even though the fan is a little noisy.
Does anyone have a wiring diagram for the Clean/Overdrive,OD1/OD2 switch. There is a blue wire loose with the Red wire connecting to the Resistor for the L.E.D.
I cannot find a diagram anywhere and I am unable to use the pedal. Thanks,Van

[pecorporation]

mg100dfx.pdf

[Vanink]

Thank you for the Schematics, maybe I was not clear on my post, I actually need the wiring for the foot swith itself. I looked through the Schematics and did not see them. Thanks, Van

[Jazz P Bass]

Marshall FtSw

There is not a schematic for the footswitch itself.
There are hints on the one provided.
Page 1, top left is the switching circuit.
Page 3, bottom left is the footswitch jack.
Pin #1 (FS C) is high +5Vdc
Pin #2 (FS B) Is high +5Vdc
Pin # 4 & 5 are ground.
Insert the footswitch plug into the amp and trace out where each wire goes.

Make a drawing, scan it & post it here.

[Irok43]

vanink ..how's it goin with the footswitch problem..i too need the knowledge