Peavey valveking 112 lead channel doesn't work

[gilberty23]

I've got a valveking 112 and a lead channel stopped working.(clean channel is working fine on 100%). I've replaced all the tubes but the problem still persist.I've searched for cold joint, got the suspicious ones resoldered but it didn't helped . Can anybody help me out with this, please?

[Enzo]

MY goodness, how many places did you post this?

V2 is your dirt channel. Check tube plate and cathode voltages around that tube. Then if those are OK, apply a signal to the amp and trace it stage by stage through V2.

[gilberty23]

yeah, I just wanted to get as many different opinions as I can .
Enzo, Thank you very much

[Enoch0)))]

Have you found what was wrong with the amp? I have the same amp with the same problem. I too have replaced every tube to no avail. Any help would be greatly appreciated!

[gilberty23]

I entrusted him into the hands of servicemen. He exchanged a broken electronic components (resistors, just some), repair cost 17 euros, without warranty (with warranty 34). lead channel is working properly again.