blackstar dc power jack replacement

[nosaj]

Anyone have an idea where I could source one of these? If it were mine I'd just cobble something together, being for a store not so sure.

Thanks,
nosaj

[The Dude]

What part is broken? If it's the jack part, you could dremel it off the plastic plate and use a DC jack with a nut.

[nosaj]

Yeah its the jack part, was just pondering the very thing. not sure I have one in stock have to go to the Ham shop for that( Here in our neck a ham has taken to a flea market booth and offering a better than Radio Shack selection)
nosaj

[Enzo]

Or just order that one, pass the cost along to the customer, and get on with your life.

[The Dude]

They're out of stock, or I'm sure he would.

[nosaj]

Except that one wasn't available. So I thought I'd ask for any other suggestions.
nosaj

[Enzo]

Oh...

Then I like Dude's idea. I have never seen that exact jack with the wide plate.

[nosaj]

Ok here is what we went with. I took an on hand dc jack enlarged the hole a little on the black plate(Dc jack has a lip on it so it doesn't go through hole all the way). Took some black epoxy and welded it together, cured in the oven 1 hr. Put it back together. Dc power pack plug is dodgy. Found a nos suitable end wired it in . Heat shrinked the end and left some for pulling action. Fired it up amp is a little interesting but basically just a line 6 style amp in stereo Blackstar Stereo 10 idcore.

nosaj

[asfi]

What is the size of the jack (i.e. ID and OD measurements of the barrel)?

[nosaj]

Its already gone back to the owner. So I don't ave any info for you.

nosaj