First amp build

[big_teee]

Nice photos Terry. Would also like to see gut shots if your willing to post.
Cheers,
Tom

I'm hesitant to show any but, Here's one.
Keep in mind this is my first and only amp built to date.
Also, it works great, I'm Done, and I'm Not Changing anything. Unless maybe a Mod or two.
This was taken after I got all the noise, and Ground issues solved, and the board was lifted several times.
There are several things if I was going to build another one I would change, and do different.
For One I would use a Narrower board. 3 inches or less. That would allow more room around the amp.
All and all it was a Great Learning Experience, and Wouldn't hesitate to do it again.
If you are Light on Tech experience I recommend a smaller starter kit for a first build.
Also use a predrilled Chassis, a ready made Turret Board, That was most of the work.
The PPIMV Mod, Bias Pot and Test Points, Fills it up and Adds to the Clutter.
Terry

[jmaf]

When it comes to Gut Shots, Everyone is pretty Judgemental, and Opinionated.

I'm not opinionated but I'd like to give my opinion on it. Haha.
Looks great, Terry. All excellent components and very clean build. I might get there one day.

[big_teee]

I'm not opinionated but I'd like to give my opinion on it. Haha.
Looks great, Terry. All excellent components and very clean build. I might get there one day.

jmaf, Can You tell I Have been Rattle Snake Bit a Few Times, with Pictures.
B_T

[jmaf]

jmaf, Can You tell I Have been Rattle Snake Bit a Few Times, with Pictures.
B_T

Gut pictures?

[jks5601]

Nice work, Terry! Appreciate the schoolin' on board width and chassis. I'm thinking of effects loop with a 'Send Level' pot in lieu of the bias circuit if I can find room and -oh yeah, the brains to figure that part out..
Cheers
Kevin