Pickup Gaussmeter v.3.0

[Bill Scheltema]

Elepro

Hi there,

Not sure why you can't get through. I went through my setup and all is checked for allowed as far as email PM's are concerned.
You can try again.

Bill

[Bill Scheltema]

Elepro

Just got the payment request and sent it off. Thanks.

Bill

[belwar]

payment sent and THANK YOU.

[-Elepro-]

thanks at all...
i will ship tomorrow....

bye

[David Schwab]

I placed my order with mouser, Here is the Mouser part number ( 563-PBS-11327-B )for the box that David Schwab referenced above.

Yes, I got it from Mouser:

PBS-11327-B Bud Industries Enclosures, Boxes, & Cases

[-Elepro-]

all shipped....

bye

[BadHorsie]

my box from Mouser Electronics just showed up. I am ready roll once the board gets here.

[copperheadroads]

what about the mouser order . do we have to that our selves ?

[BadHorsie]

what about the mouser order . do we have to that our selves ?

Yes, you can order it at your own leisure. I ordered mine as soon as I was sure I was getting a PCB from -Elepro-

[David King]

My new PCB and pic arrived today. Thanks Mr Elepro!

[copperheadroads]

Yes, you can order it at your own leisure. I ordered mine as soon as I was sure I was getting a PCB from -Elepro-

so is everybody ordering there orders on there own or is this a group buy as well. what else do i need the sensor and a enclosure ..anything else ?

[-Elepro-]

My new PCB and pic arrived today. Thanks Mr Elepro!

miiiinchia in 4 days.....


someone else received it?

[BadHorsie]

-Elpro-, mine was in the mailbox this morning. That is 5 days to Texas. ( Smoking Fast). Know how to I separate (cut) the sensor probe from the rest of the PCB? @copperheadroads, this is not a group buy, you will have to purchase on your own you can follow the link to mouser on the front. Look at the following post reply :3, 35, 57, 65 looks like this will be all that you will need

[-Elepro-]

Please note

someone changed the quantity of some component in the mouser basket link in reply #3.... compare quantity with list in that reply....

[-Elepro-]

Know how to I separate (cut) the sensor probe from the rest of the PCB?

i cut mine with a small hacksaw and then moulded pcb probe with dremel and a small sanding drum like this....

bye