Summer Fund Drive:C'mon guys lets show some support! If this site has helped you an you haven't recently donated Include your username so I know whos donatingPlease consider making a donation. :)
Just wondering if any one has made a jig to test wire tension, and somehow calibrate your feed tension.
Cheers.
I tension with a pair of heavy felt pieces sandwiched between two pieces of metal with a thumbscrew to loosen or tighten that the wire passes through before landing on the bobbin. I use a dynamometer tension gauge to measure the tension between winds. Never went the the effort to fabricate one that measures tension on the fly as tension never seems to change much for me once set.
Take Care,
Jim. . .
VA3DEF
____________________________________________________
In the immortal words of Dr. Johnny Fever, “When everyone is out to get you, paranoid is just good thinking.”
Thanks for your answer, but I'm talking about a jig that let's you set a particular tension before starting the wind. At the moment I have a dial tension gauge, and I simply tie wire to it, hold it in one hand, then drag my tensioner away in the other. it does give me a reading and I can tweak the tensioner so it is roughly the same each time I want to wind at that particular tension. Of course after 4 or 5 pulls, the felt starts to sort of polish the wire and the tension reading starts to reduce a little. I was thinking about building some sort of jig that dragged the tensioner away from a dial gauge at a constant rate. Just wondering if anyone else has tried anything like this...
Comment