No announcement yet.

Connector help

  • Filter
  • Time
  • Show
Clear All
new posts

  • Connector help

    Apologies if this is in the wrong place.

    Need help identifying this connector and where to obtain.

    I searched DigiKey and the Molex site with no luck.

    Thanks for any assistance.

    The world is full of people that are right.

  • #2
    Not sure on the size but this looks close...CBK Supply - Ic-Conn T-shaped 2-pin Dc connector 1/4" push-fit blades; male & female housings on Amazon , if size is different, maybe CBK Supply can help.
    Click image for larger version

Name:	IC Conn.jpg
Views:	29
Size:	7.8 KB
ID:	908629
    Last edited by shortcircuit; 07-01-2020, 10:39 PM.


    • #3
      very similar but mine doesn’t have the latch.
      Friction fit.
      It’s the connector for a car heat/ac blower motor on the Vintage Air Magnum Gen IV unit.

      It does have 1/4" spade terminals.

      Edit; The Vintage Air website is not much help.
      I'll shoot them an email.

      Or.... I'll just cut the connectors off and use some commonly available power connectors.
      Last edited by galaxiex; 07-01-2020, 11:05 PM.
      The world is full of people that are right.