line 6 HD100 mkII spider valve schematic?

[Off-Beat]

Can't seem to get hold of it... Just need to find out what the drive pot is so I can replace it

[nickb]

Can't seem to get hold of it... Just need to find out what the drive pot is so I can replace it

Line 6 don't give out schematics

[Off-Beat]

Thought so , think this is the pot I need 10k Pot but they don't ship to the uk

[nickb]

Thought so , think this is the pot I need 10k Pot but they don't ship to the uk

This might be close enough Line 6 HD100

[Off-Beat]

Thanks! Would u happen to know the name of that type of pot?

[nickb]

Thanks! Would u happen to know the name of that type of pot?

It looks like the ones Marshall use in the MG https://www.cedist.com/products/R-VMG-10KL If it is, that shouldn't be so hard to get hold of.

>This< looks like it will work but you'll need to file a flat

[nickb]

Thanks! Would u happen to know the name of that type of pot?

Not sure - the APLS RK09L look close. Measure yours and compare.

>RS< have them

[Off-Beat]

Thanks! Il prob order those ones

[doctor]

Line 6 defines this pot as “pot mono 10KB linear taper 25mm W/9mm Nut D-shaft”

[Jazz P Bass]

Has the OP tried contacting ANY authorized Line 6 repair center???

I have purchased Line 6 items from the local guy in Allentown, Pa.

[Drewline]

I think this may be the schematic you are looking for. Send me your email & I will forward it to you. The forum will not let me upload it.

[Off-Beat]

Thanks guys. I got it sorted, the pot Nick suggested done the trick!