Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

Sencore Super Cricket user manual wanted

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Sencore Super Cricket user manual wanted

    I just picked up one of these at a junk shop and need the user manual if anyone has a scan. It's a TF30 - the benchtop mains operated unit.

  • #2
    Originally posted by Mick Bailey View Post
    I just picked up one of these at a junk shop and need the user manual if anyone has a scan. It's a TF30 - the benchtop mains operated unit.
    I know it's an earlier version , but maybe it helps out?
    nosaj

    http://www.cbtricks.com/miscellaneou...orrections.pdf
    soldering stuff that's broken, breaking stuff that works, Yeah!

    Comment


    • #3
      Yes, thanks. Just a few extras on my model I have, though it now looks like mine is faulty. I need to check the probe voltages and to see if a square wave is being generated.

      The circuit looks quite different, though.

      Does anyone have the schematic? I think one was supplied with the unit when new.

      Comment


      • #4
        Just found the service manual. Rather strange that the only copy I could find was buried in a Lima radio station's web site.

        TF30.pdf

        Comment


        • #5
          I've fixed it and it works fine. Actually, I never thought about wanting/needing a transistor tester, but it's pretty useful. I ran through a whole load of random Soviet transistors in no time at all. No need even to look up the pinouts before connecting the leads.

          Comment


          • #6
            i'm having trouble with mine. what did you find wrong with yours?

            Comment


            • #7
              On mine the interconnecting wires are terminated in IDC connector blocks. Over the years these connections had oxidised. I removed each wire individually, cut of the bad end and soldered it back where it came from. I then made sure all the rest of the contacts were clean - just a spray with contact cleaner and a bit of 'working' and It's been working fine since.

              After my initial enthusiasm I didn't use it for a while but I dusted it off and it's back on my bench testing transistors for fuzz circuits. Just using it for gain and leakage, but I find it a lot easier to use than my digital meter that's 40 years younger.

              Comment


              • #8
                thanks, will check that out on mine.

                Comment

                Working...
                X