Announcement

Collapse
No announcement yet.

Hughes & Kettner Statesman Dual EL84 service manual

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hughes & Kettner Statesman Dual EL84 service manual

    Hi, guys, greetings from Brazil!

    I know it's very hard to find, but, anyone have the schematic of this amplifier? I have one in the bench now with burned resistors in the output path.

    Thanks in advance.

  • #2
    Have you tried contacting Hughes and Kettner directly?

    http://hughes-and-kettner.com/support/contact/

    If no luck there, please post some pictures. We may be able to figure it out. There are only so many ways to build a dual EL84 amp.
    "I took a photo of my ohm meter... It didn't help." Enzo 8/20/22

    Comment


    • #3
      Hi, The Dude.

      Yes, i tried more than three times without any response.

      About the pictures, i'll provided later (i don't have a good definition camera now).

      Comment


      • #4
        What are resistors?

        Comment


        • #5
          I'm pretty sure Dr meant to say " What are the resistors?" i.e what are they connected to? Do they look like high or low power ones? A picture would help.
          Experience is something you get, just after you really needed it.

          Comment


          • #6
            I was referring to the resistor numbers, for example R45.

            Comment


            • #7
              Dear Doctor and TheDude,

              Thanks to your help and sorry for my later reply.

              After some searching, i found the right values of resistors (unfortunatly, because the Covid19 i'm very far from my workshop in these days), here is:

              - R59: 1K/3W;
              - R73: 1K/3W.

              Both are in power stage (open). The two output tubes (EL84) has died, too.

              R82: 220K 1/4W (power supply), show some burn marks.

              I ordered these parts from a local dealer and try to return with the whole picture when i received it.

              Again, thanks for the support.

              Comment


              • #8
                Dear Gansoguitar

                If you have Statesman Dual EL84 service manual or schematic please share or upload on music-electronics-forum.
                Maybe some other user will need it.

                Thanks in advance
                vk
                It's All Over Now

                Comment


                • #9
                  "- R59: 1K/3W;
                  - R73: 1K/3W."
                  Screen resistors.
                  Try this Tube 20 schematic for the output section.
                  Attached Files

                  Comment


                  • #10
                    Originally posted by vintagekiki View Post
                    Dear Gansoguitar

                    If you have Statesman Dual EL84 service manual or schematic please share or upload on music-electronics-forum.
                    Maybe some other user will need it.

                    Thanks in advance
                    vk
                    Dear vintagekiki,

                    ​​​​​​Unfortunatly i didn't have it, i just get the information based in an photo from one guy in internet, but it helps to elucidate these parts.

                    Comment

                    Working...
                    X