Announcement
Collapse
No announcement yet.
Search Result
Collapse
16 results in 0.0050 seconds.
Keywords
Members
Tags
-
A dirty pot was the culprit.
-
I am not sure if this is a dumb question or not but, does that have to be done from the under side of the pcb with the tubes still in, or should I pull the...
Leave a comment:
-
Those 2 conditions could be heat related, right?
It still sounds the same, just quieter. Volume at 10 on that channel is barely above "bedroom"...
Leave a comment:
-
Ok. I will do that as soon as I get a chance to open the amp up....
Leave a comment:
-
[QUOTE=lowell;396340]Must be before IC4 which mixes the 2 channels back together. It could be V1 or V2 preamp tubes or any related component. What is your...
Leave a comment:
-
Actually, I didn't really make a difference. It was good for maybe a minute, then went bad again. I put an oven mit on and wiggled the tubes a bit, made no...
Leave a comment:
-
Carvin X60B help.
Hi. I have a 1986 Carvin X60B, and the volume is very low on the lead drive channel. The clean channel is louder on 1 than the dirty channel on 5. It used...
-
how's this project coming? i have a filmosound 385 i just pulled out of a projector. i'll be looking for help soon.
Leave a comment:
-
I have been checking out that site too, and the prices are almost too good to believe. I was particularly interested in the lil puncher and lil killer pickups....
Leave a comment:
-
I was curious about that MXR pedal. I think I should check it out.
Leave a comment:
-
I bought a MIM standard Telecaster about 4 years ago with no regrets. I had played almost every Telecaster in my local Guitar Center and kept going back to...
Leave a comment:
-
I don't know the answer to your question, but that looks like an interesting pedal. How do you like it?
Leave a comment:
-
EQ pedal suggestions/opinions
I am considering buying an EQ pedal. Can anyone make any suggestions, or give opinions, either good or bad? Thanks.
-
I have been using a Voodolab Sparkle drive. I like the clean boost.
Leave a comment:
-
Cheap a** phase 90 pot
Hi. The cheapo plastic shaft on the pot of my MXR phase 90 broke. What pot do I need to replace it with? What else should I do to it while I have it apart?...
-
Leave a comment: