Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.2031 seconds.
Keywords
Members
Tags
-
You have to work from a no load situation and varify the tranformer will operate without a load and all the voltages are correct and the primary isn't shorted....
-
Had a guy die on me and didn't know it until I googled it and found the recent orbituary. It was an Ampeg VL-2000 Lee Jackson that I modded and still use...
Leave a comment:
-
Glad I've been gone for so long didn't have to deal with that lol. Get it together tboy lol!
Leave a comment:
-
SVT 7 Pro Help.
Have a SVT 7 Pro that is turning off after about 5 seconds then back on and off again stuck in this cycle with no load connected.
I found some dark...
-
SVT 5 Pro 06A565 Preamp Schematic
Anyone possibly have one ? Not the same as the 07S565. Close but not quite. TIA
-
Soooo now I've got this thing totally apart and thinking now that maybe I do have some bad MOSFET's as I lifted some resistors to check the string and found...
Leave a comment:
-
-
That's basically what the KF Komet Amps that my buds at Riverfront Music are building now and are really nice sounding amps. Granted the owner probably works...
Leave a comment:
-
Just my opinion but Imo the fender stages really don't create a good distortion tone because they were never intended to be a distortion amp. Leo built it...
Leave a comment:
-
If pin 1 is internally connected to pin 8 than they aren't 6CA7's, they are tetrodes. A true Pentode has pin 1 isolated by itself. Most tubes these days are...
Leave a comment:
-
No I'm telling you to take the signal from after the coupling cap on either the 6au6 or the 12AX7 (b) and send it to the tip of the phono in jack.
...
Leave a comment:
-
-
True but without monitoring current it's really hard to say what it's doing under load but I highly doubt it would sag as much as a linear supply. There could...
Leave a comment:
-
Yes true J M the power-transistors are attached to the bottom of the amp on the transformer side using the old timer mounting screws....
Leave a comment:
-
You can check them to see if they are all glowing but that won't tell you how they are operating it's just verifying the heaters are all lighting up all the...
Leave a comment:
-
That amp was designed in Hartleys garage way back when and I've worked on a few as well. As Enzo said there is really not much to this amp and in all reality...
Leave a comment:
-
Well it's not going to be enough for what you are wanting. One problem is you have a mic input tranny that is looking for 150 ohms impedance and you are sending...Last edited by Amp Kat; 02-27-2016, 11:04 AM.
Leave a comment:
-
Make sure your jumper connection is clean and didn't jump over to another component or wire. The only other thing that would cause that is a short somewhere...
Leave a comment:
-
Usually when that happens it's either a wiring issue or something you put back in the wrong place. Make sure you have it wired up correctly.
...
Leave a comment:
-
If you do use a GL6 the 5881 Sovtek Military grade will take over 1000+ volts and still live to tell his buds about it.
Leave a comment:
Leave a comment: