So...
I managed to wire it all up again with the wires on the correct points. The amp powered up and the filaments bright again, played through but couldn't hear any signal at all out either side...
also after I switched the amp off - the step down transformer died - neither fuses from either the transformer or the plug blew so it's odd. Any ideas what the cause might have been?
I'm going to take a break now from the soldering and look at it again tomorrow probably
*edit*
sloppy fault checking on my part - it was the plug fuse in the transformer, I checked the wrong plug (whoops)
so hopefully the transformer is ok
I managed to wire it all up again with the wires on the correct points. The amp powered up and the filaments bright again, played through but couldn't hear any signal at all out either side...
also after I switched the amp off - the step down transformer died - neither fuses from either the transformer or the plug blew so it's odd. Any ideas what the cause might have been?
I'm going to take a break now from the soldering and look at it again tomorrow probably
*edit*
sloppy fault checking on my part - it was the plug fuse in the transformer, I checked the wrong plug (whoops)
so hopefully the transformer is ok
Comment