JBL EON 515XT No Power On

[ca7922303]

Got it going. Really appreciate the help. Going to leave it running for awhile before I claim it good. Thanks.

[ca7922303]

Got it going. Really appreciate the help. Going to leave it running for awhile before I claim it good. Thanks.

Had it on for about an hour now and still going. Guess it was C645(melted) and K600 relay(soldered pins 3 to 4). Thanks again for all the help.

[nosaj]

I would not give it back to customer like that. Thst is rigged an not a proper repair. Doing that to the relay is just a trouble shooting technique.
nosaj

[ca7922303]

I would not give it back to customer like that. Thst is rigged an not a proper repair. Doing that to the relay is just a trouble shooting technique.
nosaj

I'm the customer, don't mind it being rigged while I wait for relay to be delivered.

[ca7922303]

I would not give it back to customer like that. Thst is rigged an not a proper repair. Doing that to the relay is just a trouble shooting technique.
nosaj

Know anything about the JBL light on the front of it not working?

[nosaj]

Know anything about the JBL light on the front of it not working?

Is it shown in the schematic?
nosaj

[ca7922303]

Don't recall seeing it, wondering if anyone might have run across one before, at work till this evening, will check schematic then.

[g1]

Some powered speakers have a multi-function front light that is set by a switch on the control panel. Check owners manual.

[ca7922303]

Some powered speakers have a multi-function front light that is set by a switch on the control panel. Check owners manual.

It has an on/off recessed button on the control panel, but not working and don't see anything on it on the schematic or owner's manual.

[Jazz P Bass]

Logo switch is on the mixer schematic, Pg 1

[ca7922303]

Getting (14.88vdc) at logo light leads with switch off, and (0.00mvdc) with logo switch on.

[nosaj]

take off the grill
nosaj

[g1]

If you have 15V going directly to leads of light, and it is not lit, it is bad.
Is it an LED stuck to the plate?

[ca7922303]

I removed four(4) screws on what looks like back of control module and not getting access to it. Read somewhere that there may not be any access to control module?

[g1]

The logo light is on the front grille, isn't it? You said you measured at the leads to the light, a picture of what you measured would help.