HELP !!! Kurzweil K2000 FET protection circuit instructions

[dinokamber]

Hello good people! Today I got output protection board, six transistors and four wires (two longer, two shorter). I bought this from France via ebay, Please, if anyone has instructions document or manual or something like that for installation this board??? Thank you very much. Cheers...

[dmeek]

Some information here https://reverb.com/item/29612609-kur...ection-circuit

The board protects the output muting FETs. The 6 new FETs are included in case the originals are blown.

More info here https://music-electronics-forum.com/...ection-circuit

[dinokamber]

Thank you dmeek. Yes, this is that board from that seller! As you can see, on the list below he wrote to deliver with the package and instructions but I did not receive it. That is a problem.. I dont know where to solder three wires (+12,-12 and AGND) and another six wires from protection board. I supose direct to jack (positive pin)...

[Jazz P Bass]

The SM can be had here: Kurzweil K2000 Service Manual (Page 132 of 133) | ManualsLib
There are 3 12 Vdc voltage regulators used.
+12 for the hard drive
+ & - 12Vdc for the circuits.
Vr 3 & VR 6.

[Enzo]

So contact the seller and tell him you got no instructions.

[dinokamber]

SOLVED !!! Thank you guys for help. I got instructions where to connect all wires. Six black wires goes to TIP contacts on all output jacks, from J9 to J15. +12v goes at U35-pin 8, -12v at U35 - pin 4 and AGND at U35 - pin 5. Thats all ! Thanks again and take care of yourself.... Cheers!