Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.2496 seconds.
Keywords
Members
Tags
-
The smaller single coil sized blade bobbins use a fairly small magnet between the rails (usually Ceramic) as for the large humbucker sized bobbin you do...
-
That is even on the big side for 42 gauge wire it should be like .0023"...
- Likes 1
Leave a comment:
-
I have spacers cut to an accurate height that i use to get the correct coil height . i also have flatwork jigs that do this as well...
- Likes 1
Leave a comment:
-
I do have a set of Gibson embossed pickups here that came out of my sg200 . i can take some measurements if you like...
- Likes 2
Leave a comment:
-
Good question . I was hoping it can do the traverse with multiple pitches /TPL ....
Leave a comment:
-
this cnc winder
Has anyone tried this winder for winding pickups ?
https://www.ebay.ca/itm/183281320594...6-89093-2056-0...
- Likes 1
-
Most likely they are wound with 44 gauge wire & none of Fender standard pickups have any kind of scatter to them ,...
Leave a comment:
-
Pickup winders use number of turns NOT DCR as a measurement of some sort . as soon as you figure this out , these questions become irrelevant & you have...
- Likes 1
Leave a comment:
-
Tried emailing them many times & the email message has failed . so it's just a dream as far as I know .
Leave a comment:
-
-
Interesting !!! .I've never understood the pinout & possibilities of a 4 way , if you can share a crude drawing i can make a decent wiring diagram if...
Leave a comment:
-
Click the "post" tab up top of the page ,I had the same problem when it was on the "latest activity" tab...
Leave a comment:
-
I wipe it off the flat surface ,No need to get it out of the holes . the residue is around the holes . .. easy peasy ....
Leave a comment:
-
I just use a coarse dry rag ,A face cloth , but it's done by hand ....
Leave a comment:
-
-
-
I cant look at it when I click the pdf it takes me the the main MEF page .
Leave a comment:
Leave a comment: